Sony CMT-RB5 - Manual (Page 26)

26
Troubleshooting (continued)
A stereo FM program cannot be received
in stereo.
• Press STEREO/MONO until “STEREO”
appears in the display.
• See “There is severe hum or noise (“TUNED”
or “STEREO” flashes)” on page 25, and
check the antenna condition.
If the system still does not
operate properly after
performing the above measures,
reset the system as follows:
With the system turned on, press s, FUNCTION
and ?/1 at the same time.
The system is reset to the factory settings. All the
settings you made such as the preset stations,
clock and timer are cleared. You should set them
again.
Specifications
Main Unit
Amplifier section
The following measured at 220 V AC, 50/60 Hz
DIN power output (rated): 10 + 10 watts
(4 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
12 + 12 watts
(4 ohms at 1 kHz, 10% THD)
The following measured at 240 V AC, 50/60 Hz
DIN power output (rated): 12 + 12 watts
(4 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
15 + 15 watts
(4 ohms at 1 kHz, 10% THD)
Inputs
MD/VIDEO (AUDIO) IN (phono jacks):
voltage 500/250 mV, impedance
47 kilohms
Outputs
MD/VIDEO (AUDIO) OUT (phono jack):
voltage 250 mV, impedance
1 kilohm
PHONES (stereo minijack):
accepts headphones of 8 ohms or
more.
SPEAKER: accepts impedance of 4 to
16 ohms.
CD DIGITAL OUT OPTICAL:
Optical