Sony DCR-TRV480 - Manual (Page 100)

Dubbing/Editing 100
13
Touch [START].
14
Touch [EXEC].
A search for the beginning of the first
program starts, then the recording starts.
[SEARCH] appears during the search and
[EDITING] appears during editing.
When a program is recorded, the program
mark changes from orange to light blue.
When all programs have been recorded, the
program editing operation stops
automatically.
To cancel recording, touch [CANCEL].
To end Digital program editing
Touch [END].
To save a program without using it to
record
Touch [CANCEL] in step 13.
The program is stored in memory until the
cassette is ejected.
To erase programs
1 Follow steps 1 to 6 in “Recording the
selected scenes as programs” (p. 98),
then touch [UNDO].
2 Touch [DEL 1MARK] to delete the last
set program. Or, touch [ALL ERASE] to
delete all the programs.
3 Touch [EXEC] .
The programs are deleted.
To cancel this operation, touch [CANCEL].
b Notes
• You cannot set the starting point or ending point on
a blank section of the tape. If there is a blank section
in the picture set as a program, the total time may not
appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 11 on
p. 95, and set the [IR SETUP] code.
START 0:00:00:00
CANCEL EXEC
ENGAGE
REC PAUSE
TOTAL
SCENE 0:00:00:25
3
SEARCH 0:00:00:00 –x1
END
SCENE 1/3
CANCEL