Sony KDX-46Q005 - Manual (Page 66)

Using the Remote Control
64
KDX-46Q005
2-592-150-12(2)
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the TV’s remote control, use the following procedure to program the
remote control.
1
Turn to the list of “Manufacturer’s Codes” on page 65, and find the
three-digit code number for the manufacturer of your equipment. (If
more than one code number is listed, use the number listed first.)
2
Press repeatedly until the DVD/VCR, SAT/CABLE or i.LINK
indicator lights up.
3
Press for five seconds until the indicator of the selected input
flashes.
4
While the desired indicator is flashing, enter the three-digit
manufacturer’s code number.
5
Press .
6
To check if the code number works, aim the TV’s remote control at the
equipment and press
that corresponds with that equipment. If it
responds, you are done. If not, try using another code listed for that
manufacturer.
Function Equipment Programmable Code
Number
DVD/VCR Sony DVD player 751
SAT/CABLE Sony Satellite Receiver 801
i.LINK Sony DVD player (i.LINK) 901
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
✍
You must do step 5 within 10 seconds of step 4, or you must redo
steps 4 through 5.
✍
If more than one code number is listed, try entering them one by one
until you come to the correct code for your equipment.
✍
If you enter a new code number, the code number you previously
entered at that setting is erased.
✍
In some cases, you may not be able to program your remote control to
operate other equipment. In such cases, use the equipment’s own
remote control.
✍
Dead batteries or removing the batteries may cause the programmable
codes to be lost and revert back to factory settings. Reprogramming the
codes may be necessary.
3, 6
2
4
5