AVerMedia Technologies NV 6000 EXP User Manual

Page 71

Advertising
background image

Chapter 5 Customizing NV DVR System

62

- Enable/disable

the

Abnormal Event

check box, to set the condition of the event for

system to alarm.

Normal Reboot: when the NV DVR system reboot without abnormal condition,

the system will send out the alarm message.

Abnormal Reboot: when the NV DVR system reboot in irregular condition, the

system will send out the alarm message.

Recording is switched off: when the recording has been stopped, the system

will send out the alarm message.

Network is switched off: when the network connection of DVR system is lost,

the system will send out the alarm message.

Hard Disk failed: when the hard disk can’t work normally, the system will send

out the alarm message.

Temperature: set a temperature limited of system for system to alarm. When

DVR system temperature is over the temperature limited, the system will send
out the alarm.

i

Temperature setting only supports on NV6000 Express card.

Illegal Entry: any objects move between selected regions which user has set up

in Object Counting section (see

Chapter 5.2.1

), the system will send out the

alarm. Select the entry (object moves from region 1 to 2 or from region 2 to 1)
and camera for system alarm detection.

i

Only the camera has been setup in Object Counting will be available
for selecting in Illegal Entry.

- Enable/disable

the

POS Keyword

check box, to scan the data from the POS if it

matches the keyword (see also

Chapter 5.9.10

).

- Enable/disable

the

Alarm Message

check box, to active with external alarm

message by your own program. For the detail configuration, please contact the local
reseller.

-

Continue trigger duration:

Set a time period that when sensor has been trigger

and stay in the same status for that period, then the alarm will be sent out.

6. In

(5) Alarm Reset

, click the camera number (use W and X to select the alarm) to set the

reset condition of alarm. Once alarm is reset, all alarm action will stop at the moment. If
the sensor normal status is high, set the sensor condition to low.

Advertising