AT&T P5962 - Manual (Page 13)

11
Telephone Operation
HANDSET2 2
BASE 0
HANDSET3 3
^ V OK
VO LU ME SPEAK ER
Basic handset operation
Hold
During a conversation, select
HOLD
to place a call on hold.
CALL ON HOLD
will be displayed for 4 seconds and an
H
will appear in the upper left corner of the display. Press the
corresponding key (
LINE 1
or
LINE 2
) to resume the call.
NOTE : If the call is not resumed in five minutes the set will ring. The display
will show CALL ON HOLD RING BACK!. If the RING BACK is not answered
in 30 seconds, the call will end.
If you are on a call on the other line, your call will not be interrupted by the RING
BACK for the held line. The call on the held line will end in five minutes with no
warning.
Call transfer
During a conversation you can transfer the call to the base
or to another handset.
Press
XFER
to display a list of handsets and base. Use
the ^V buttons to highlight the set you want, then select
OK
to transfer the call to the remote set. A person at the
remote set can press
LINE 1, LINE 2 , or the
INTERCOM/TRANSFER
button to receive the transferred
call.
NOTE: If the transferred call is not answered in 30 seconds, the call will be
returned to the originating handset. Thirty seconds later, the display of the
originating handset will show CALL ON HOLD RING BACK!. If the RING BACK is
not answered in 30 seconds, the call will end.
You can announce to the base or to another handset that you will transfer the call
to them by selecting HOLD and then pressing XFER. This will send an intercom
signal. When the intercom call is answered, you can talk privately. After the inter-
com call ends (by pressing OFF on the handset or INTERCOM on the base), the
call will be transferred.
H
HOLD MUTE VOL
91-000302-050-000_EP5962Englishmanual_Sep.02,2005.qxd 2/13/1950 7:21 PM Page 11