Aussie MECO 7110 - Manual (Page 8)

Step 4) Install Drip Cup:
Insert Drip Cup into Drip Cup Holder ring until
the cup flange is flush with the ring and the
notch in the lip of the cup fits the vertical
hanger wire.
(17) DRIP CUP
Align groove
with vertical
wire
Step 3) Assemble Hood/Bowl to Cart:
(15) BOLT, M6X45
4 PC
(16) M6 LOCKNUT
4 PC
FIG. 3A
FIG. 3C
(16) BOLT, M6X45
(15) M6 Nut
(14) HOOD/BOWL ASSEMBLY
Bowl Bracket Legs
8
Bowl/Leg Bolts
Left and Right
Sides
FIG. 3B
View Inside Bowl
NOTE: REQUIRES 2-PERSONS
· With Cart upright, align Bowl Bracket legs with
Cart legs. (FIG. 3A)
· Lower Hood/Bowl so ends of Cart legs insert
into Bowl Bracket legs.
· Press downward until leg screw holes align.
NOTE: If cart legs do not align and fit into
Bowl Bracket legs easily, loosen the Control
Panel bolts slightly. Then open the Hood and
loosen the 2-Bowl/Leg bolts on either, or
both sides of the Bowl. (FIG. 3B)
· Insert M6x45 Bolts from the outside through
the legs and tighten with M6 Locknuts.
(FIG. 3C)
· Re-tighten all Bolts.
Control Panel
Bolt on each
side of grill