Avaya 16-300310 - Manual (Page 19)

Configure H.323 video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use [email protected] August 2010 19
Configuring Ad-hoc Video Conferencing for a Polycom RMX Video
Conferencing Bridge Platform
To configure Ad-hoc conferencing for a Polycom RMX video conferencing bridge platform,
perform the following steps:
Table 9: Configuring Ad-hoc video for Polycom RMX video Conferencing Bridge Platform
1 Perform the procedures in the section Table 8: Configuring Polycom RMX Series Video
conferencing on Bridge Platform on page 13 to configure the Polycom RMX system.
2 Enter display system-parameters customer-options to verify the Maximum
Administered Ad-hoc video Conferencing Ports (page 2 of screen). The maximum
number of Ad-hoc video conferencing ports allowed is the sum of the ports on your
RMX systems. For example, if you have an RMX20 system and an RMX80 system, the
maximum number of ports is 100.
3 Enter change cos to set Ad-hoc video Conferencing (page 2 of screen) for the
appropriate COS levels.