Avaya 16-300310 - Manual (Page 8)

Configuration of SIP video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use [email protected] August 2010 8
Administration of Avaya Series 1000 Video Conferencing and
Avaya one-X
®
Communicator video endpoints and users using
System Manager
Perform the following steps to configure all Avaya Series 1000 Video Conferencing Endpoints
and Avaya one-X
®
Communicator with SIP video. This section describes how to use System
Manager to create an endpoint template and how to add users using these templates.
Creating a template
Table 2: Creating a template
1
Creating a custom template for any SIP endpoint on System Manager
1. Click Elements > Templates > Endpoint, select Communication Manager 6.0
on the Endpoint Templates page and click New. Set the following
parameters:
●
Set Type : 9630SIP, an alias for the 1000 series endpoints
●
Template Name : Avaya recommends naming the template according to its
AV10x0 type and Communication Manager release, such as
AV1010_CM_6_0.
●
COR : 1
●
COS : 1 or an appropriate cos group for priority video calling and bit-rate
management
Note:
Note:
This applies to priority video users and is not required for minimal
administration. See Avaya video Conferencing Solutions Networking
Guide 6.0 for further details.
●
SIP trunk : AAR or specific SIP trunk used between System Manager and
Communication Manager
2. Select the IP video check box.