Avaya 16-300310 - Manual (Page 24)

Configure H.323 video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use [email protected] August 2010 24
4
Use the add signaling-group command to add a signaling group for the
gatekeeper. Set the following parameters:
●
Group Type: H.323
●
IP video: y
●
Priority video. If you want all incoming calls to receive priority video
transmissions, select y
●
Near-end Listen Port: 1719
●
LRQ Required: y
●
Far-end Node Name to the name you entered for the gatekeeper in Step 3.
●
Far-end Listen Port: 1719
●
Far-end Network Region to the IP network region you specified in Step 2.
●
Direct IP-IP Audio Connections: y
●
IP Audio Hairpinning: y
5
Use the add trunk-group command to add a trunk group for the gatekeeper. Set the
following parameters:
●
Group Type: ISDN
●
Carrier Medium: IP
●
Add members to this trunk group
6
Use the change signaling-group n command (where n is the signaling group
you added in Step 4) to set Trunk Group for Channel Selection to the trunk group you
added in Step 5.
7
Create a route pattern to the gatekeeper.
8
Configure the gatekeeper.
Table 11: Administering Polycom PathNavigator/ CMA Gatekeepers