Avaya 16-300310 - Manual (Page 15)

Configure H.323 video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use [email protected] August 2010 15
Configuring Polycom Endpoints
Use this procedure to configure the Video calling facility for all Polycom endpoint users.
Add Users/stations to Polycom endpoints
Use this procedure to add users/stations to the Polycom endpoints.
Table 6: Configuring Polycom Endpoints
1 Enter display system-parameters customer-options to verify the Maximum
Video Capable Stations (page 2 of screen). This number is provided by the RFA license
file. The Maximum Video Capable Stations was determined using the following criteria:
●
Each V500/700 system is considered to be one station
●
Each single-point VSX/HDX system is considered to be one station
●
Each VSX multpoint system can be three to six stations
Each HDX system can be three stations for multipoint plus four and seven for multipoint
plus eight multipoint licensed options for the HDX9004. The HDX9002 only has
multipoint plus 4 as an option.
2
Enter change cos to set Priority Video Calling (page 2 of screen) for the appropriate
COS levels.
3
Enter add station to add a station for the Polycom system. Set the following
parameters:
●
Type :H.323
●
Security Code : the “pin” you will administer for the VSX, HDX, V500 or V700
system
●
IP Video : y
●
If you want this station to be able to make priority video calls, make sure you
select a COS level that has Priority Video Calling enabled. (See Step 2)
●
On page 2 of the screen, set Direct IP-IP Audio Connections to y
Note:
Note:
You can create an alias for VSX/HDX stations.