Agilent Technologies 1100 Series User Manual
Page 13
2
Connecting the Hardware
Installing a Network Card in an Agilent Module
Thermo Scientific
Agilent 1100 Series LC Devices Connecting the Hardware and Triggering Data Acquisition
5
Y
To install the network interface card in an Agilent module
1. Make sure the module (usually the detector) is turned off and unplugged from line
power.
shows the location of the power switches.
When the power switch of a module is in the On position, the LED on the switch is
green. When you turn the power switch of a module to the Off position, the LED
turns off.
If your LC stack contains a detector (for example, diode-array detector, variable
wavelength detector, multiple wavelength detector), install the network interface card in
the detector. If your LC stack does not contain a detector, install the network card in any
module with an open slot.
Figure 1.
Front panels of the Agilent 1100 Series modules
CAUTION To avoid electric shock, unplug the power cable that connects the Agilent
module to line power. After you turn the power switch to the Off position, the power
supply continues to draw current.
Tip You can install an Agilent LAN interface board (model G1369A) instead of a
JetDirect 400N network card.
1100 Series
1100 Series
1100 Series
1100 Series
F1
F8
i
m
F7
F6
F2
F3
F4
F5
9
8
7
5
6
4
1
2
3
0
.
-
Esc
Enter
◄
◄
Detector
Power switch
Column
compartment
Autosampler
Binary pump
Solvent cabinet
Power switch
Power switch
Power switch
On position
Off position