Safety precautions, Contacting us – Agilent Technologies 1100 Series User Manual
Page 6
Preface
vi
Agilent 1100 Series LC Devices Connecting the Hardware and Triggering Data Acquisition
Thermo Scientific
Safety Precautions
To connect the Agilent 1100 Series LC stack to a Thermo Scientific mass spectrometer, you
must install an external contact board in one of the Agilent modules and a LAN interface
board in a second Agilent module. To install a board, you must remove the cover from the
optional board slot.
shows the location of the slot on the back panel of the
detector.
Before you remove the slot cover from an Agilent 1100 Series module, do the following:
• Turn the power switch to the Off position and unplug the power cable.
• Refer to the Reference Manual for the module for additional safety information and for
information on preventing ESD damage caused by an electrical discharge.
Contacting Us
There are several ways to contact Thermo Fisher Scientific.
Y
To contact Technical Support
Find software updates and utilities to download at
Note Highlights information of general interest.
Tip Helpful information that can make a task easier.
CAUTION To avoid an electric shock, always turn off an Agilent module and unplug
it from line power before you remove its cover.
CAUTION To prevent damage to an instrument, always use ESD protection when
handling electronic boards and components.
Phone
800-685-9535
Fax
561-688-8736
Knowledge base