Agilent Technologies 1100 Series - Manual (Page 15)

2
Connecting the Hardware
Connecting the Ethernet Communication Cables
Thermo Scientific Agilent 1100 Series LC Devices Connecting the Hardware and Triggering Data Acquisition 7
Connecting the Ethernet Communication Cables
Y To connect the Ethernet communication cable to an Agilent 1100 Series LC
1. Connect a category 5, shielded Ethernet cable from the JetDirect 400N network card to
the Ethernet switch.
2. Connect a category 5, shielded Ethernet cable from the Ethernet switch to the Ethernet
card in the computer dedicated to the LC system (typically network interface card
number 3).
Figure 3. Ethernet connections
CAUTION To comply with safety and EMC regulations, you must use category 5,
shielded Ethernet cables to make the Ethernet connections for your instrument.
HEWLETT P
A
CKARD
JET DIRECT 400N
BNC
BNC
100 (RJ-45)
100 (RJ-45)
HEWLETT P
A
CKARD
JET DIRECT 400N
Not drawn to scale
USB
ENET
Cat5 shielded
Ethernet cables
Ethernet Switch
JetDirect 400N card
(installed in one of
the Agilent modules)
Computer
Optiplex GX520
(subject to change)