A&D Check Weighing Scales FS-6Ki - Manual (Page 13)

11
Note for the Legal for Trade Models
‰ The range for power-on zero is within ±10% of the weighing capacity around the
calibrated zero point.
‰ The ZERO key will zero the scale if the weight is within ±2% of the weighing
capacity around the power-on zero point. The ZERO annunciator turns on. When
the weight exceeds ±2% of the weighing capacity, the key does not work.
7-4. Weighing with Preset Tare
Using PT key, known tare weight can be entered via the 10-key pad.
1. Remove everything on weighing pan.
2. Press the PT key. The display will blink with the preset tare weight previously
entered, or will show blank if there is no preset tare entered.
3. Use the 10-key pad to display the known tare weight.
‰ If you hit the wrong key, press the C key to return to the display at step 2 and try
again.
4. Press the ENT key. The weight display changes to net weight mode and the NET
annunciator comes on.
5. Place the item together with the tare (container) to display the net weight.
7-5. To Clear a Tare Weight
Either:
1. Remove all items from the weighing pan.
2. Press the ZERO key. Then the display will go to zero and tare will be cleared.
‰ The NET annunciator goes off.
‰ In some countries or areas, the ZERO key does not clear the tare weight. Press
the TARE key after zeroing at step 2. Then the tare weight will be cleared.
Or:
1. Press the PT key. The display will blink with the preset tare weight previously
entered, or will show blank if there is no preset tare entered.
2. Press the 0 key and .press the ENT key.
3. The tare weight is cleared and the NET annunciator goes off.