Airstream INTERNATIONAL CCD - Manual (Page 35)

C
C - 6
CAMPING
CABLE/SATELLITE TV WIRING SATELLITE ANTENNA WIRING
If you compare the two drawings above you’ll see wiring for a satellite
dish antenna is relatively simple.
Units have a faceplate with two coax cable hook-ups. The faceplate has
a small coax cable jumper running between the hook-ups to complete
the cable TV circuit when in use. To install a satellite system use the
following procedure:
1. Remove the jumper wire from the coax faceplate.
2. Hook a portable dish into the Cable TV receptacle in the roadside rear
underbelly compartment. This feeds the dish signal to the input side of
the faceplate.
3. Install the satellite receiver input and output into the dual coax
faceplate.
To return to a cable TV system, remove the satellite receiver from the
faceplate and reinstall the jumper cable.
COAXIAL CABLE WITH CABLE HOOK UP
COAXIAL CABLE WITH SATELLITE HOOK UP
Exterior Cable TV Hook Up
Exterior Cable TV Hook Up
Dual Coax
Faceplate
Dual Coax
Faceplate
Jumper
Cable
TV
TV
TV
TV
Satellite Antenna
Front TV Jack
W/Booster
Front TV Jack
W/Booster
Satellite
Reciever
TV Antenna
TV Antenna
Antenna Lead in
Antenna Lead in