Panasonic SCAK331 - Manual (Page 20)

RQT7799
4
To household
AC outlet
(R) (L)
1
2
1
2
Set-up
5
AC power supply cord
3
Speakers
Placement
Connect the AC power supply cord only after all other connections have been made.
Optional antenna connections (A page 11)
Preparation
Twist and pull off the vinyl tip of the antenna wires and speaker cords.
OR
If the speaker cords do not have vinyl tips, directly connect them to the terminals.
Insertion of connector
Even when the connector is perfectly inserted, depending
on the type of inlet used, the front part of the connector
may jut out as shown in the drawing.
However there is no problem using the unit.
GCP only
If the power plug does not fit your socket, use the power
plug adaptor (included).
The included AC power supply cord is for use with this unit only. Do not use it with
other equipment.
For your reference
To save power when the unit is not to be used for
a long time, unplug it from the household AC outlet. You will need to reset some
memory items after plugging in the unit.
4
GCP only
Voltage selector
Use a flat-head screwdriver to set the
voltage selector on the rear panel to the
appropriate position for the area in which
this system is used.
1
FM Indoor antenna
2
AM loop antenna
Stand the antenna up on its base.
Adhensive tape
Affix where
reception is best.
Place the front speakers so that the super tweeter is
on the inside.
Connector
Appliance inlet
Approx. 6 mm
Note
• Keep your speakers at least 10 mm away from the system
for proper ventilation.
• These speakers do not have magnetic shielding. Do not
place them near televisions, personal computers or other
devices easily influenced by magnetism.
• You cannot take the front net off the speakers.
Caution
• Use the speakers only with the recommended system.
Failure to do so may lead to damage to the amplifier and/
or the speakers, and may result in the risk of fire. Consult
a qualified service person if damage has occurred or if
you experience a sudden change in performance.
• Do not attach these speakers to walls or ceilings.
Use only the supplied speakers.
The combination of the main unit
and speakers provide the best
sound. Using other speakers can
damage the unit and sound quality
will be negatively affected.
Notes on speaker use
• You can damage your speakers
and shorten their useful life if
you play sound at high levels
over extended periods.
• Reduce the volume in the
following cases to avoid
damage.
– When playing distorted sound.
– When adjusting the sound
quality.
Connection
When the unit is first plugged in, a demonstration of its functions may
be shown on the display.
If the demo setting is off, you can show a demonstration by selecting
“DEMO ON”.
Press and hold [DISP, –DEMO].
The display changes each time the button is held down.
NO DEMO (off)
DEMO ON (on)
While in the standby mode, select “NO DEMO” to reduce power
consumption.
Note
DEMO function cannot be turned on when Dimmer is on.
DISP, –DEMO
Red (+)
Blue (–)
Gray (+)
Black
Blue
Red
Gray
Black (–)
Connect the
left (L) side in
the same way.
VOLT ADJ
220–240V
110–127V
Turning the demo function on/off
Super tweeter Super tweeter
PL GCP PL GCP
Main unit
Front
speaker
(right) Front
speaker
(left)
Note