Panasonic 26PST1U6 - Manual (Page 16)

16
USING WIRELESS REMOTE CONTROLLER
How to Install Batteries 1. Press and slide the cover on the back of the wireless remote controller in the direction of the
arrow.
2. Install two AAA alkaline batteries (LR03). Make sure the batteries point in the direction marked
in the battery compartment.
3. Press the reset hole, then replace the cover. If you press it, the current time, ON time, and OFF
time are all reset to 0:00.
• The batteries last about six months, depending on how much you use the wireless
remote controller. Replace the batteries when the wireless remote controller’s lamp fails
to light, or when the wireless remote controller cannot be used to change the air
conditioner’s setting.
• Use two fresh leak-proof type-AAA alkaline batteries (LR03).
• In replacing batteries, follow the instructions as mentioned in the sub-section “How to
Install Batteries”.
• If you do not use the wireless remote controller more than 1 month, take out the
batteries.
Reset hole
Cover
Information for Users on Collection and Disposal of Old Equipment and used Batteries
[Information on Disposal in other Countries
outside the European Union]
These symbols are only valid in the European
Union. If you wish to discard these items,
please contact your local authorities or dealer
and ask for the correct method of disposal.
Note for the battery symbol (bottom two
symbol examples):
This symbol might be used in combination with
a chemical symbol. In this case it complies with
the requirement set by the Directive for the
chemical involved.
163011_SingleSplit_EN_2.fm Page 16 Thursday, September 15, 2011 9:03 AM