Panasonic 26PST1U6 - Manual (Page 20)

20
OPERATION
Setting Current Time
After changing the batteries and pressing reset, be sure to reset the current time.
(When reset is pressed, the current time reverts to [
])
1. Press for two seconds or more.
Once the clock displays starts blinking, the clock can be set.
2. Set the hour with / of the .
If you press and hold the button, the time changes quickly.
3. Set the minutes with / of the .
If you press and hold the button, the time changes quickly.
4. Pressing completes the time setting.
• While you are setting the current time, the t ime display flashes but the colon does not.
• If the buttons are not pressed for three minutes while setting the current time, it is set to the
displayed time.
When reset is pressed, the timer settings are deleted.
Operation
Auto , Heat , Dry , Cool , Fan
Models that only provide the cooling function cannot operate in the auto or heating modes.
Power: Turn on the power of the indoor unit at least 14 hours before operation.
1. Press .
2. Press and select from among Auto , Heat , Dry , Cool and Fan .
3. Press and select the desired speed.
If set to Auto , the fan speed switches automatically.
(Auto does not work when in the Fan mode.)
4. Press one of the buttons and set the desired temperature.
Temperature settings cannot be made when in the Fan mode.
Stop: Press .
When the unit is stopped with the remote controller, even though the compressor of the
outdoor unit stops, the fan on the outdoor unit may continue to run for a while.
If the unit is not heating very effectively with a Low fan speed , switch the fan speed to High or Medium.
Depending on the indoor unit being used, it may indicate a function that it does not have. (The fan speed is set.)
If you cannot turn the air conditioner off in the normal way.
Disconnect the power to the indoor unit and contact the dealer where the product was purchased.
Auto Heat Dry / Cool
MAX 80 78 86
MIN 62 60 64
2 3 1, 4
NOTE
2
3
1
4
163011_SingleSplit_EN_2.fm Page 20 Thursday, September 15, 2011 9:03 AM