AltiGen comm IP 710 - Manual (Page 25)

IP 710 Manual 17
Miscellaneous Operation Notes
• Logging in and out—When using #26 and #27 to log out / log
in, the IP 710 must be onhook. Pressing the Speaker button and
then using #26 or #27 will not work.
• BASIC mode—If the IP 710 phone fails to register with
AltiWare during startup, the phone operates in Basic mode.
When in Basic mode, the IP phone’s LCD display shows
(BASIC) IDLE.
No AltiWare switching features are available in this operating
mode. However, the phone user can enter a destination IP
address followed by #, and make an outgoing call through the IP
network to reach AltiWare or another IP 710 phone. Also, the IP
phone can accept incoming calls originating from AltiWare or
another IP 710 phone.
If the IP phone’s local configuration is changed while in BASIC
mode, the changes are overridden by AltiWare Administrator
settings.
• Incoming call takes priority—If a call comes in while you are
using any phone menu or display (such as workgroup display or
Call Log), the phone will exit the menu and go to the ring state.
• Restoring default settings—To automatically restore the
original default settings for the IP 710 phone:
1. Press the Menu button.
2. Press * * 2, then press the Enter button.
• Rebooting the phone—To reboot the IP 710 phone, press * * 3,
then press the Enter button.