Acnodes FPC 8084 - Manual (Page 58)

FPC 8084 User s Manual
A.2.6 PNP/PCI Configuration
This section describes the PCI bus system configuration. PCI or
Personal Computer Interconnect is a system which allows I/O devices
to
operate at speeds nearing the speed of the CPU when
communicating with its own special components. This section covers
some very technical items, and it is strongly recommended that only
experienced users should make changes to the default settings.
Phoe nix – Award BIOS CMOS Setup Utility
PnP/PCI Configur ations
PNP OS Installed No Item Help
Reset Configuration Data Disabled
Resources Controlled By Manual
Menu Level f
X IRQ Resources Press Enter Select Yes if you are
X DMA Resources Press Enter using a Plug and play
capable operating
PCI/VGA Palette Snoop Disabled system select No if
Assign IRQ For VGA Enabled you need the BIOS to
Assign IRQ For USB Enabled configure non-boot
devices
ЗИЖЕ : Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F 1:
General Help
F5: Previous Values F 6: F ail-Safe Defaults F7 : Optimized Defaults
PNP OS Installed
This item is to determine install PnP OS or not. The options available are
Yes and No.
Reset Configuration Data
Normally, this field is Disabled . Select Enabled to reset Extended
System Configuration Data (ESCD). W hen exiting Setup or installed a
new add-on, the system reconfiguration has caused such a serious
conflict that the operating system cannot boot. The options available are
Enabled and Disabled.
56