Panasonic TH-65PF10RK - Manual (Page 15)

1/2
Signal
PC
Off
Standby save Off
Power management Off
Auto power off Off
OSD Language English (UK)
Component/RGB-in select
RGB
Input label
Power save
Setup
INPUT MENU ENTER/ + / VOL - /
INPUT MENU ENTER/ + / VOL - /
15
Initial selections
.......(Japanese)
.......(Chinese)
Italiano
Français
Deutsch
English(UK)
Español
ENGLISH(US)
Selecting the On-Screen Menu Language
Press to display the Setup menu.
Press to select the OSD Language.
Press to select your preferred language.
Selectable languages
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the SLOT.
• Select to match the signals from the source connected to the component/RGB input
terminals. (see page 41)
• In 2 screen display, the same input mode cannot be selected for the main picture and
sub picture.
• Image retention (image lag) may occur on the plasma display panel when a still picture
is kept on the panel for an extended period. The function that darkens the screen
slightly is activated to prevent image retention (see page 52), but this function is not
the perfect solution to image retention.
Selecting the input signal
Select the input signals to be connected by installing the optional Terminal Boards.
Press to select the input signal to be played back from
the equipment which has been connected to the Plasma
Display.
Input signals will change as follows:
INPUT1 INPUT2 PC INPUT3
Press the INPUT “1”, “2”, “3” or “PC” input mode selection
button to select the input mode.
This button is used to switch directly to INPUT mode.
These buttons can only display the slot which is installed.
If you press the button whose slot is not installed, it
automatically displays the current input signal.
When a dual input terminal board is attached, A or B is
displayed depending on the selected input signal. (Ex.
INPUT1A, INPUT1B)