Acroprint timeQplus TQ600 - Manual (Page 34)

- 26 -
1:N Verification (“One to Many” Verification)
In this mode, a user simply takes a fingerprint reading. The TQ600
compares their fingerprint to all of the fingerprint templates stored
in the terminal. 1:N verification takes more time than 1:1
verification. The verification time is dependent on the number of
fingerprint templates stored in the terminal.
1) Place finger on the sensor surface, the following appears:
2) It continues for about 0.5 seconds. If the test is successful, the
following appears:
3) If your identity cannot be verified, you are prompted to try
again, the following appears:
It continues for about 0.5 seconds, return to the start-up window.
Verify
User ID 00001
Verified.
FP Verify
Remove Finger
FP Verify
Please Try Agn.