EXONIC EXD 7088GPS2 - Manual (Page 28)

24
4. Route Plan
Once you have entered your destination and confirmed it is correct, you will be taken to the Route Plan screen; from here
you can begin navigating, carry out a simulation of the route or add additional waypoints to the journey.
Kudos Navigation System enables to two waypoints during navigation. The system calculates a proposed route according to
the sequence of the waypoints you specified, and guides you to the final destination.
4.1 Navigating
To begin navigating to you entered destination tap . The unit will begin to calculate a route from your current
location to your destination. Once calculated the screen will change to the route navigation screen and you are ready to
drive.
While you are navigating it is still possible to browse the map. Note that the unit will continue to navigate if you are moving,
but your position on the map will not be updated and no voice prompts will be given. Tap to return
or wait for 10 seconds after which the unit will automatically resume normal navigation.
While the unit is calculating the route you can tap “Cancel” at any time to cancel the route and return back to the Route Plan
screen.
4.2 Waypoints
You can add up to two additional destinations before you begin navigating, these additional destinations are known as
waypoints. When the unit calculates the route it will navigate you to each waypoint first before continuing on to your final
destination. This is handy if you are planning a trip were you would like to stop off on the way to take in sights or simple
just for a break/fuel.
4.3 Simulate
Before you navigate a route for real you can simulate the route on the unit. To simulate the route tap , you
will be asked if you would like to change your starting point. Your current starting point will be your current position on the
Picture 4.1 Route Plan