HOUNO BM ovens - Manual (Page 9)

9
PROGRAMMING
Baking programs
The baking programs have been pre-programmed by the manufacturer. Check that the settings
match your products.
Changing a baking programs
Choose a program key – for instance. Set the time, oven chamber temperature, humidity
pulsing, fan speed and exhaust. Store the new program by pressing . Keep pressing the key
for 5 – 10 seconds until you hear a short beep and the figures stop changing.
Memory function / timer function
This function which offers the possibility of entering 10 programs each holding up to 4 program
steps is particularly suitable for baking of dough products. Can also be used as timer.
Activating a program
Choose a program number and press ON/OFF. When the program starts, the time
remaining in the step in question is shown
.You can browse through the entire program by
repeatedly pressing .
If there is only one step, A, its settings and a vacant B are shown. By pressing after B, you
go directly to the program number.
Entering a program
When you receive the oven, the computer memory is empty. You can enter the settings in a process
step by choosing and pressing until step A is shown in the display. Then press
, for instance, and the settings possible for step A are shown in the display. Apply the same
procedure for steps B, C and D.
Deleting a step
You can delete steps by pressing until you reach the last step in the program. Then, to delete
the step, press the baking mode whose control lamp is on, i.e. you delete steps backwards.
Storing programs
Store the settings by pressing when you are at the program number .
Alarm between steps – for preheating or baking of products requiring different baking times
Activate the alarm by pressing until the control lamp in the key lights. The alarm stops
when the door is opened.
Load the oven and close the door. The program continues automatically the moment the door is
closed.
Timer function – postponed preheating of oven
Press in a vacant step to set the time. Note that only the time in the display should be active –
not the temperature. The timer is not a clock, therefore you must count the hours ahead.
In step B, set the preheating time at, for instance, 20 minutes, the temperature at 250°C, fan speed
high and exhaust closed.
Return to manual operation – baking programs
To return to manual operation, press when the display shows the program number, i.e. you
cannot go directly from steps A, B, C or D to a baking program.