Merrychef eikon e6 - Manual (Page 7)

E2 SERVICE MANUAL REV D 09/12
7
1 3
8
9 10 11 12
MAIN FEATURES
1 ON/OFF SWITCH
ON (I) activates the oven, OFF (0) switches the oven to
standby mode. IT DOES NOT ISOLATE INTERNAL WIRING
FROM THE MAINS SUPPLY.
2 CONTROL PANEL
Touch sensitive controls (easyToUCH) for controlling
oven functions, including diagnostics and service mode.
3 USB menuKey
A socket, located under the logo, allows a USB menuKey to
be used to update the cooking programs and oven
firmware on the control board.
4 OVEN CAVITY
The oven cavity is mostly constructed from stainless steel
panels which must be kept clean to avoid contamination
of food products and allow the oven to perform at peak
efficiency.
5 JET PLATE
Direct air into the cavity. It must be cleaned on a regular
basis, and kept free of debris.
6 OVEN DOOR
The twin-skinned door has a thermally insulated inner
section to lower the surface temperature and
incorporates a microwave choke.
7 DOOR SEAL
Provides a tight seal around the door and must be kept
clean. The seal must be checked regularly and replaced if
worn or damaged.
8 AIR FILTER
The air intake provides cooling air for internal components
and must be cleaned daily and must NOT be obstructed.
The filter must be in place for the oven to function
properly.
9 STEAM VENT
Vents steam from the oven cavity.
10 SPEC PLATE
The spec plate, located on the rear oven cover, states the
Model, Serial Number, and Electrical Ratings.
11 MAINS ELECTRIC POWER CABLE
Located on the rear of the oven and must be replaced if
worn or damaged.
11
8
9
10
1
2
3
4
5
6
7