Merrychef eikon e6 - Manual (Page 9)

E2 SERVICE MANUAL REV D 09/12
9
OVEN PLACEMENT/INSTALLATION
INSPECT OVEN
• Inspect oven for damage such as dents in door or inside oven cavity.
• Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged.
• Remove all packing materials from oven interior.
(Note: Check all packing material as accessories may be stored in oven interior.)
• If oven has been stored in extremely cold area, wait a few hours before connecting power.
OVEN PLACEMENT
• Do not install oven next to or above source of heat, such as pizza oven or deep fat fryer. This could cause microwave
oven to operate improperly and could shorten life of electrical parts
• Install oven on level countertop surface
• If provided, place warning label in a conspicuous place close to microwave oven
• Outlet should be located so that plug is accessible when oven is in place
• Provide clearance as shown in Figure 5 and described in the following paragraphs:
a) The unit must have 2” (51 mm) of air gap on either side as well as at the rear.
b) Air intake temperature should not exceed 110°F/45°C. Excessive temperature will lead to reduced operating duty
cycle, or premature aging of internal components. Failure to comply with these conditions will invalidate the
warranty.
c) A built-in catalytic converter eliminates the need for a ventilation hood so the oven can operate in virtually any
environment.
Figure 5 Oven Clearance Dimensions
HANDLING & STORAGE:
• When moving an oven always observe and follow National and local requirements for lifting and moving heavy
objects. Do not use the oven door handle to lift oven.
• When not in use, electrically disconnect the oven and store safely in dry cool place, do not stack ovens.
NOTE:
Upon receipt of this unit, immediately unpack and inspect for possible concealed shipping damage. If unit
is found to be damaged, save all packing materials and contact your delivery carrier immediately. Failure
to follow these instructions will negate Merrychef USA’s or your ability to file claims and receive
compensation for shipping damage.
IF THERE IS APPARENT DAMAGE: United States and Canada: Arrangements should be made to file a
claim against the carrier. As Interstate Commerce Regulations require that the claim must be initiated by
the consignee. All shipments to other countries: Freight terms will be developed and extended on an
individual basis.
Proper and secure storage facilities should be arranged for the oven(s), if necessary, to protect from
outdoor or damp conditions at all times before installation.