Merrychef 402s - Manual (Page 14)

14
CLEANING: 3
• ALWAYS switch off at the electrical supply and allow oven to cool before cleaning
See COOL DOWN PROCEDURE
• CAUTION: Allow the oven and accessories to cool before commencing cleaning
*When replacing impinger plates and the cavity grease
filter use firm finger pressure to tighten fasteners
DO NOT USE TOOLS
DO NOT
USE TOOLS
WARNING: DO NOT use caustic cleaners on any part of the oven or oven
cavity as it will cause permanent damage to the Catalytic Convertors
DO NOT spray directly into the fan opening at the rear of the oven
Equipment: Merrychef oven cleaner, Merrychef Oven Protector, heat proof gloves, protective rubber gloves, non–
abrasive nylon scrub pad, cleaning towel and cloths, eye protection and dust mask (optional)
COLD OVEN: CLEANING INSTRUCTIONS ( following cool down )
Wash all parts in warm soapy water. Wash off using a clean cloth and plenty of
clean, warm water. Dry using a fresh, clean cloth.
Remove top impinger
plate
Remove the rack and lift
out bottom impinger plate
Undo fasteners
Remove grease filter
undo the 4 thumb
screws
3.
Wash off using a clean
cloth and plenty of clean
warm water to rinse top,
sides and back of oven.
Dry using a fresh clean
cloth or paper towel.
Wipe the outside of the
oven with a damp cloth. 1.
Wear protective rubber
gloves and protective
glasses carefully spray
Merrychef Oven Cleaner
onto the internal surfaces
of the oven except door
seals.
DO NOT spray directly
into the fan opening at
the rear of the oven 2.
For difficult areas leave
to soak for 10 minutes.
Leave the oven door open
during cleaning.
Use a non–abrasive
nylon scrub pad/sponge
to clean all internal
surfaces and the inside
of the door. 4.
Replace clean oven
parts
Grease Filter*
Top plate*
Bottom plate*
Air filters x2
CAUTION: Wear protective rubber gloves when cleaning the oven
Remove air filters
both sides
Oven Parts and filters
& Oven Cavity
If the door seals are damaged, the oven
must be repaired by an approved Servicer.
DO NOT use the oven without clean
air filters and cavity grease filter in place