Merrychef 402s - Manual (Page 8)

8
AIR OUTLETS
These vents on the rear panels enable air which
has been used to cool internal components to
escape. It will not allow microwave energy to
escape into the environment. They must be kept
free from obstruction.
OVEN CAVITY
The cavity is constructed from stainless steel and
vitreous enamelled panels. It must be kept clean
(see CLEANING).
CONVECTION FAN, GREASE FILTER & CATALYTIC
CONVERTOR
The convection fan, which is located behind the
catalytic convertor pulls air in through the filter which
removes the majority of the smoke from the air flow.
The air is then heated and returned to the cavity
through the impinger plates to produce an even
heat pattern in the oven. This layout minimises
areas where grease build up can occur.
Great care should be taken when cleaning this area
of the oven - please note the cleaning requirements
pages 12-14.
The metal grease filter grill covering the fan must be
kept clean and free of debris (See CLEANING)
AIR INLET FILTERS ( LEFT & RIGHT )
Situated at the left and right hand side of the base at
the front. These are part of the ventilation system
and must be kept free of obstruction and cleaned
on a daily basis.
DOOR HANDLE
This is a rigid bar which is pulled downwards and
towards you to open. CONTROL PANEL
See page 10.
ON/OFF SWITCH
When switched ON, the control panel will illuminate.
The fan and ventilation system will also operate.
RATING PLATE
Found on the rear panel, this states the serial
number, model type & electrical specifications.
DOOR
This is a precision-made energy barrier with three
microwave safety interlocks. It must be kept clean
(see CLEANING section). The door should NOT be
used to support heavy dishes.
DOOR SEALS
These ensure a tight seal around the door. They
should be kept clean and checked regularly for
signs of damage. At the first sign of wear they
should be replaced by a Merrychef approved Service
Agent.
STEAM VENT (on rear of oven)
This enables steam to escape and prevents build
up of condensation. It will not allow microwave
energy to escape.
MenuKey 2
Changes the programs on the oven ( See MenuKey
section for downloading programs on a MenuKey).
Rack
Should be removed daily for cleaning
(see CLEANING section). 1
2
3
4
5
7
8
9
10
11
12
MAIN FEATURES
6
3
6
5
2
4
12
11
7
8
9 10
1
Rear view
4
13
13
1