ARRI ARRIFLEX 416 - Manual (Page 12)

ARRIFLEX 416 Quick Guide 04/2007, Page 12
Camera Display - Options
Setting the Total Exposed Film Counter
A new feature of the 416 is the option to enter a total exposed fi lm quantity.
• Make sure the display is in mode 1 (black bar visible). If not, repeatedly
press MODE until it is. If PS/CCU shows in the display, press NORM.
• If the take counter is displayed in mode1 switch to total exposed film as follows:
– Press MODE twice to enter mode 3.
– Press SEL twice.
– Press SET once to switch the positions of the take and total exposed film counters.
– Repeatedly press MODE until mode 1 is displayed.
• Use the SEL button to select the digit you wish to change, which will flash.
• Use the SET button to change the value of the flashing digit. No confirmation is necessary.
Resetting the Total Exposed Film Counter
• Repeatedly press the MODE button until the total exposed film counter is
displayed (mode 1 or 3).
• Press and hold the SET button until the counter resets (approximately 3 seconds).
Beeper, Backlight & ARRIGLOW
The upper line of display mode 6 allows the user to decide whether and when the
beeper sounds and how loud (LS is shown for ‘loudspeaker’). The left-hand bar
shows the status of the start beep. The right-hand bar shows the status of the stop
beep. In each case, with the bar in the high position the beep will sound, in the
low position it will not. The fi nal digit is the volume, which is adjustable between
0 (off) and 3.
The lower line of display mode 6 controls the brightness of the control buttons
backlight. This can be set between 0 (off) and 3.
The ARRIGLOW on the 416 gives the user a choice of frameglow colours.
Colours 1 – 8 are preset colours followed by U, which is user adjustable by
setting individual red, green and blue values. The ARRIGLOW brightness is
adjusted with the + and – buttons above the camera display.
Changing the Beeper and Backlight settings
• Use the SEL button to select the digit you wish to change, which will flash.
• Use the SET button to change the value of the flashing digit.
Changing the RGB ARRIGLOW colours
• Push the + DIMMER button on the camera left side so you can see the
ARRIGLOW in the viewfinder.
• Set the display to mode 7.
• Pushing the SEL button will make the ARRIGLOW number flash. Pushing the SET
button will now cycle through preset colours 1 – 8 and then user adjustable
colour “U”. Stop at the colour you like – no confirmation is necessary.
• To change the user adjustable colour, push SEL again while U is flashing. The
SEL button will now cycle through the red (r), green (G) and blue (b) values of
the user colour. Pushing the SET button changes the flashing colour value from
0 (no colour) up to 16 (maximum colour). No confirmation is necessary.