On-board battery – ARRI ARRIFLEX 416 User Manual
Page 13
ARRIFLEX 416 Quick Guide 04/2007, Page 13
On-board Battery
On-Board Battery OBB-2
The OBB-2 On-Board Battery attaches directly to the camera body by means of a quick change mechanism
that can be easily operated with one hand. The OBB-2 incorporates a built-in power meter to indicate the state
of charge, while an extra contact in the power connector communicates this information to the camera. When
an OBB-2 is connected, display mode 3 can additionally show battery capacity (in percent) or remaining
camera running time (in hours). The remaining running time is calculated from the load on the camera since it
was powered-up and assumes the loading from accessories will not change.
Note: The new 416 power connector on the camera remains compatible with standard ARRI 24 volt power cables.
Mounting the OBB-2
•
Fit the power plug of the OBB-2 into the camera power connector and slide the battery forward.
Removing the OBB-2
•
Hold the OBB-2 as shown in the picture below and press the on-board battery release button.
•
Pull the battery backwards until the power connectors disengage.
On-board Battery
On-board Battery
release button
Battery power meter