ARRI ARRIFLEX 416 - Manual (Page 17)

ARRIFLEX 416 Quick Guide 04/2007, Page 17
416 Side Bracket (SBR-2)
The Side Bracket can be attached to the 416 and
supports the MB-20 I & II matte boxes using either
19 or 15 mm rods. A 5 mm hex wrench is needed
to fix the two mounting screws.
416 Lightweight Support (LWS-5)
A sturdy bracket for 15 mm lightweight support rods
that attaches to the 416 by three screws - a 5 mm
hex wrench is needed.
416 Low Mode Support Set (LMS-2)
416 Steadicam Plate
Because the LWS-5 projects below the line of the camera base a riser plate needs to be added when the 416
is top mounted on a Steadicam. The 416 Steadicam Plate adds the necessary distance and offers numerous
3/8 - 16 mounting holes.
Accessories
Low Mode Bracket
Use on its own for the lowest low
mode confi guration - viewfi nder
needs to be removed to clear
Steadicam plate.
Low Mode Riser
Allows use of Steadicam plate
with the viewfi nder fi tted.
Low Mode Support Handle
Fits in 3 positions facing
forwards or back to optimize
camera balance.
Screw 1
Screw 2
Screw 3 Screw 1
Screw 2