ARRI ARRIFLEX 416 - Manual (Page 7)

ARRIFLEX 416 Quick Guide 04/2007, Page 7
1. Total film exposed (or take counter)
Standard speed.
2.
Programmed speed.
3. Take counter (or total film exposed)
Supply voltage & (with OBB-2),
battery capacity/running time left.
4. Timecode hours & minutes
Timecode minutes & framerate
5. Timecode User Bits
Timecode User Bits
6. Loudspeaker sequence & volume
Button backlight brightness
7.
ARRIGLOW colour
Power On, Camera RUN, Inching, Camera Display
Turning Camera Power On
The Power On button for the ARRIFLEX 416 is located above the RUN button on the camera right side. To turn
the camera On, briefly press the Power On button. When a battery is connected to the camera and the power
switch is turned on, you should see characters appear on the Display on the camera left side.
Note: The camera remembers the status of the Power On button and restores this status after a power interruption.
Camera RUN
To run the camera, press any RUN button briefly. The RUN indicator light will glow red while the camera
comes up to speed, changing to green once the set frame rate is reached. The RUN indicator light will glow
steadily green while the camera runs at the set frame rate. To stop the camera, briefly press the RUN button
again. If the RUN indicator glows red while the camera is in Standby, the camera is not ready and pressing
the RUN button will have no effect.
Note: If the PHASE button has not been pushed after power on or after a new magazine has been attached, the
first time RUN is pressed the camera performs a 2 second loop check before running.
Inching
The ARRIFLEX 416 cannot be manually inched – it can only be inched by pressing the PHASE button while
the camera is in Standby. If the PHASE button is pressed briefly, the mirror shutter will open to allow for gate
checks. To move the mirror shutter back into viewing position, press the PHASE button again briefly.
Camera Display Overview
ON/OFF
RUN
LCS
LCS
TCC
RF CHAN
ZOOM
RS RS
NORM PS/CCU LOCK
RUN
MODE SEL/∆ SET/ V
PHASE
Display Indicators: asy: Asynchronous operation (camera is not running at set fps)
bat: Low battery (OBB-2: 23 volts, other batteries: 20.6 volts)
end: Camera has run out of fi lm
fps fl ashes: ESU is not receiving a valid signal
TC glows: Timecode exposure is enabled and timecode is set
TC fl ashes Timecode exposure is enabled but not recording properly
Viewfi nder Indicators: LED glows: Asynchronous operation (camera is not running at set fps)
LED fl ashes Low battery (OBB-2: 23 volts, other batteries: 20.6 volts)
Power On button
Camera right
RUN button
PHASE button
RUN indicator
Camera left
RUN button