Pitco Frialator SRTE14-2 Dual Electric Rethermalizer - Manual (Page 13)

SRTE: Electric Floor Model Rethermalizer
OPERATION
9
Maximum Recommended Product Capacity (after 195°F preheat)
2160 in³ Total (12x 180 in³ bags or equivalent) per tank
2.3. APPLIANCE START UP
Refer to the following procedure to start the appliance prior to operation.
1. Ensure that the drain valve is closed.
2. Fill the cook tank with water. (See section 2.1 “Filling the Appliance”)
3. Turn the I/0 (ON/OFF) switch to the I (ON) position.
4. The controller may need to be turned on. Press the
* button to turn the controller on.
*The specified button may appear slightly different then shown. Refer to the operator’s
manual for your appliance’s specific control type to determine the exact appearance of each
button and display.
5. The appliance is now on and heating the water in the cook tank.
2.4. COOKING
It is important to keep the cook tank full of water to minimize the chance of boiling the appliance dry
and to keep the water at a level that will provide optimum cooking performance. To ensure the quality
of the food you cook in this appliance, follow the preparation instructions from the food manufacturer.
2.4.1. SIMMER MODE
Simmer mode maintains the water temperature to just below boiling. This mode is used to reheat
food or as a “stand by” mode. When the appliance is turned on, it will be in simmer mode.
2.4.2. BOIL MODE
Boil mode consistently heats the water so that the water will boil. Use of this mode is not
recommended for your appliance. Not all control types include boil mode.
WARNING
Water must completely cover the heating elements at all times while appliance is on.
WARNING
NEVER operate the appliance with an empty cook tank. It may void the warranty.
Adding water after the elements have been heated may cause injuries from hot
splattering liquids and steam.
WARNING
Dry fired elements are extremely hot, will shorten its service life and may void your warranty.