Vaddio DomeVIEW Flush Mount Dome - Manual (Page 3)

Vaddio DomeVIEW Flush Mount Dome Installation and User Guide - Document 341-443 Rev C1
Page 3 of 12
Flush Mount Dome Enclosures Only (Cameras Not Included)
The Flush Mount Dome Enclosures are for use with existing or standard Sony EVI-D70 and Canon VC-
C50iR. The Dome enclosures can also be used with the Vaddio Standard EZCamera Cable system for the
EVI-D70 or the VC-C50i analog PTZ cameras. The dome enclosures without cameras are listed below:
998-9000-050 Flush Mount Dome Enclosure includes:
QTY Description
1 Plenum rated steel back can
1 White twist and lock trim ring
1 Clear dome bubble mounted to trim ring
1 Conduit connector and nut
1 Safety chain attachment plate
3 4.5” x .375 (114.3mm x 9.525mm) Hex shaped stand-offs
1 6” x 6” (15.24cm x 15.24cm) Camera mounting stage
3 8-32 x .5” Flat head screws (flush mount)
2 8-32 x .5” pan head screws
2 Lock washers for pan head screws
998-9000-070 Flush Mount Dome Enclosure includes:
QTY Description
1 Plenum rated steel back can
1 White twist and lock trim ring
1 Clear dome bubble mounted to trim ring
1 Conduit connector and nut
1 Safety chain attachment plate
3 2.75” x .375 (69.85mm x 9.525mm) Hex shaped stand-offs
1 6” x 6” (15.24cm x 15.24cm) Camera mounting stage
3 8-32 x .5” Flat head screws (flush mount)
1 6” x 6” (15.24cm x 15.24cm) Camera mounting plate (attaches to camera)
1 ¼”-20 x ½” Mounting screw (to attach camera to mounting plate)
4 8-32 x .5” pan head screws
4 #8 Lock washers for pan head screws
INSTALLATION INSTRUCTIONS
for:
DomeVIEW 50iR Flush Mount Dome System (999-9000-050)
DomeVIEW 70 Flush Mount Dome System (999-9000-070)
Flush Mount Dome Enclosures for:
CanonVC-C50iR
(998-9000-050) and Sony EVI-D70 (998-9000-070)
Before Starting the Installation
Before starting the installation of the Flush Mount Dome system, check above the ceiling where you plan to
install the camera to make sure the area is clear and that there is adequate room for the Camera Enclosure.
Make sure that the cabling required to operate the camera is brought to the point where the camera is to be
installed. For cabling requirements, see the Cabling Requirements section. All above ceiling work must
conform to local building codes and should be performed by qualified personnel.