Vaddio DomeVIEW Flush Mount Dome - Manual (Page 7)

Vaddio DomeVIEW Flush Mount Dome Installation and User Guide - Document 341-443 Rev C1
Page 7 of 12
EZCamera SYSTEM COMPONENTS
The DomeVIEW Systems are built around either the Sony EVI-D70 (999-9000-070) or the Canon VC-C50iR
(999-9000-050) and are shipped with the standard Quick-Connect, PowerRite and EZCamera Cabling Shoe.
DomeVIEW 50iR Cabling Distances with Standard and Optional Power Supplies
The DomeVIEW 50iR can transmit video up to 185 feet using the supplied 18 VDC PowerRite power supply,
and from 185 feet to 275 feet using the optional 24 VDC PowerRite power supply (part# 451-2000-024).
This EZ Camera Cabling system provides both S-video and composite video.
DomeVIEW 70 Cabling Distances with Standard and Optional Power Supplies
The DomeVIEW 70 can transmit video up to 200 feet using the supplied 18 VDC PowerRite power supply,
and from 200 feet to 300 feet using the optional 24 VDC PowerRite power supply (part# 451-2000-024).
This EZ Camera Cabling system provides both S-video and composite video.
The EZCamera Cable Shoe for the Sony EVI-D70 and Canon VC-C50iR
The EZCamera Cable Shoe attaches to the back of the Canon VC-C50iR camera and changes the native
power, video and control connectors to RJ-45s for use with Cat. 5 cabling. The Shoe has a voltage regulator
and transformers (baluns) to optimize the video signal for use over Cat. 5 cable. The RS-232C control
cabling uses 5-wires to provide for bi-directional control signaling and daisy chain control of multiple
cameras.
Figure 8:
The Canon VC-C50iR and Sony EVI-
D70 are shown with the EZCamera
Cabling Shoes attached.
The RJ-45 connectors are:
1) Power/Video
2) RS-232
IN
3) RS-232 OUT
Figure 9:
EZCamera Cable Shoe for the DomeVIEW 70 shows RJ-
45 connections for Power/Video, RS-232 IN and RS-232
OUT on the top of the Shoe (upper image). The back of
the Shoe (lower image) shows the connector labeling.
See Appendix A for pin-out information.
POWER
VIDEO RS-232
IN RS-232
OUT