Vaddio DomeVIEW Flush Mount Dome - Manual (Page 8)

Vaddio DomeVIEW Flush Mount Dome Installation and User Guide - Document 341-443 Rev C1
Page 8 of 12
CAMERA CONTROL
For the DomeVIEW 50iR PTZ and DomeVIEW 70 PTZ Flush Mount Dome Systems, the RS-232 control
programming information is in the technical manuals for the Sony EVI-D70 and Canon VC-C50iR PTZ which
can be found on the Vaddio website (
www.vaddio.com ) under the TechNotes tab and under the PTZ Camera
product grouping. Control system manufacturers’ also have programs readily available for these cameras to
be used with their control systems (i.e. Crestron® and AMX®). Please contact those companies for the
demo programs and for debugging of the programs that they provide. Both the DomeVIEW 50iR PTZ and
the DomeVIEW 70 PTZ are shipped with IR remote controllers for camera control. The camera base with
the IR window is recessed inside the dome enclosure and the acceptance angle of the IR control signaling is
affected. The angle of acceptance for the IR remote control is narrower and more directional. Please take
this into account when controlling the cameras with an IR remote.
CABLING REQUIREMENTS
For the DomeVIEW 70 and 50iR Flush Mount Dome that uses the EZCamera Cabling system, the cabling
requirements are as follows:
One (1) Cat. 5 Cable for Power/Video
One (1) Cat. 5 Cable for RS-232 control input
One (1) Cat 5 Cable for RS-232 control output for daisy chaining Sony or Canon Cameras
RS-232 OUT to
next camera for
daisy chain
control
For cabling distances using the standard and optional power supplies for the
DomeVIEW 50iR and 70, see the previous page for additional information.
RS-232 on
Cat. 5e