Vaddio WallVIEW CCU Z330 - Manual (Page 6)

WallVIEW CCU Z330
WallVIEW CCU Z330 Installation and User Guide 341-906 Rev. A Page 6 of 12
Step 4:
Take the Wall Mount, with the EZIM CCU and break out cable installed, and place it against the drywall
anchors or 3-gang wall box, making sure to pull the CAT-5 cables through the oval pass-through hole.
Finger-tighten the screws to the mount and confirm that the base is level. Tighten the screws firmly. If the
bracket is to be mounted on a 3-gang wall box, use the screws supplied with the electrical box.
Step 5:
Confirm that the CAT-5 cables are terminated correctly, by testing them with a continuity tester. Next,
connect the break out cables to the appropriate ports on the BRC-Z330 (8-pin Mini DIN is connected to
VISCA IN). Secure the camera to the mount and using the ¼”-20 screws.
Step 6:
The Quick-Connect CCU is a 1-RU rack mount interface that breaks out the signals from the Cat. 5 cables
back to the standard connectors. The basic system connectivity is illustrated in Figure 2.
Note: Plugging the POWER CAT-5 Cable into the wrong RJ-45 may cause damage to the camera system and
void the warranty.
COMPLETING THE INSTALLATION:
Connect the Vaddio 36 VDC power supply to an AC outlet. Power will travel down the Power Cat. 5 cable to
the EZIM, powering the camera. The camera will “Home” to a centered position ready for control information
from the provided IR Remote Commander or RS-232 Camera controller of the integrators’ choice. To insure
proper continuity of control and operation of the cameras, the RS-232 controller (control system or joystick)
should be powered on after the camera.
Connecting the Tally Port (optional)
The CCU system is capable of illuminating a Tally light on the front of the Quick-Connect enclosure. This
light provides a visual indicator to the equipment operator to know which camera is live during a broadcast.
In addition, on the BRC Series PTZ cameras, the tally function will illuminate the tally light on the front of the
camera lens, to allow the presenter to know which camera is live.