Initial settings and position preset, 13 basic functions – Vaddio Sony EVI-HD1 PTZ Camera User Manual
Page 13
13
Basic Functions
Initial Settings and Position Preset
The initial values are those set at the factory. Settings
for items in Position presets 1 to 6 that will be retained
even when the power to the camera is turned off are
indicated by a “O,” those that will be lost are indicated
by an “X.”
• When the power is turned on, the settings retained in
POSITION 1 will be called up as the initial settings.
• When a CAM_Memory Reset command is sent, or a
choice is made from POSITION 1 to 6 while the
RESET button on the Remote Commander is being
pressed, the settings selected will be used as the
initial settings.
• Position preset 1 becomes VISCA command
CAM_Memory memory number 0. Position presets 2
through 6 become VISCA command CAM_Memory
memory numbers 1 through 5.
Category
Mode/Position
Initial settings
Position
Position
preset 1
presets 2 to 6
Pan/Tilt
Pan/Tilt Position
Home position
a
a
Pan/Tilt Limit Position
movable-range maximum
a
×
Zoom
Zoom Position
Wide end
a
a
D-Zoom Limit
x4
a
a
Focus Position
—
a
a
Focus
Focus Auto/Manual
Auto
a
a
Near Limit Setting
7600h (10 cm)
a
×
WB Mode
Auto
a
a
WB
WB Data (Rgain, Bgain)
—
a
a
One Push WB Data
—
a
×
AE Mode
Full Auto
a
a
AutoSlowShutterLimite
1/60sec (59.94/29.97/NTSC), 1/50sec (50/25/PAL)
a
a
Shutter Position
1/60sec (59.94/29.97/NTSC), 1/50sec (50/25/PAL)
a
a
Iris Position
—
a
a
AE
Gain Position
—
a
a
Bright Position
—
a
a
Exposure Compensation On/Off
Off
a
a
Exposure Compensation Amount
±0
a
a
Backlight On/Off
Off
a
a
Apperture
Aperture Level
8
a
a
IR
IR_Receive On/Off
On
a
×
IR_ReceiveReturn On/Off
Off
a
×
OSD
Display Information On/Off
On
a
×
Effect
Picture Effect
Off
a
×
System
D-SUB 15Pin SYNC
3-STATE
a
×
Memroy
Preset Memory
Same as the initial value setting
a
a
Notes
• The number of times data can be written to the EEPROM (by executing Position Preset) is limited.
• If you want the camera status and Pan/Tilt positions in effect before the camera is turned off to be retained when the power is
turned OFF, then turned ON again, have the camera memorize those positions in POSITION 1.
• It takes approximately 2 seconds longer to memorize or erase settings in POSITION 1 than it does to memorize or erase
settings in any other channel.
• Camera ID data will be saved regardless of the position preset.