Vaddio Sony EVI-HD1 PTZ Camera - Manual (Page 38)

38
Specifications
Specifications
System
Video signal
1080i/59.94, 1080i/50, 1080p/29.97,
1080p/25, 720p/59.94,720p/50,
720p/29.97, 720p/25, NTSC
(LB), NTSC (CR), NTSC (SQ),
PAL (LB), PAL(CR), PAL (SQ)
(switched with the SYSTEM
SELECT switch)
Synchronization Internal synchronization
Image device
1/3 type (6 mm), CMOS
Effective picture elements: Approx.
2,000,000 pixels
Lens 10
× (optical), 40 × (digital) f = 3.4
– 33.9 mm, F1.8 – F2.1
Horizontal angle: 8 (TELE end) to
70 degrees (WIDE end) (When
an HD signal is output)
Minimum object distance
100 mm (4 inches) (WIDE end)
Minimum illumination
15 lux (F1.8) with 50 IRE
Shutter speed 1/2 to 1/10,000 sec.
Video S/N 50 dB
Pan/tilt action Horizontal: ± 100 degrees
Maximum panning speed: 300
degrees/sec.
Vertical: ± 25 degrees
Maximum tilting speed: 125
degrees/sec.
Input/output connectors
Video output
COMPONENT (HD OUT): D-sub
15-pin
Y: 1Vp-p (tri-level sync, at 75-
ohm termination)
Pb/Pr: ± 350 mVp-p, 75-ohm
terminated
HD/VD Sync: 1Vp-p, 75-ohm
terminated
Tri-level Sync: ± 300 mVp-
p,75-ohm terminated
HD-SDI (HD OUT): BNC type, 800
mVp-p, 75 -ohm, conforming to
SMPTE 292M serial interface
standard
VIDEO (SD OUT): RCA phono
jack 1 Vp-p, 75-ohm unbalanced
Synchronization: negative
S VIDEO (SD OUT): Mini DIN 4-
pin type
Control input/output
VISCA IN: Mini DIN 8-pin type,
RS-232C
VISCA OUT: Mini DIN 8-pin type,
RS-232C
Power connector JEITA type4 (DC IN 12V)
General
Input voltage
12 V DC (10.8 to 13.0 V DC)
Current consumption
2.5 A max. (at 12 V DC)
Operating temperature
0°C to 40°C (32°F to 104°F)
Storage temperature
–20°C to +60°C (-4°F to 140°F)
Dimensions Video camera: 259
Ч 150 Ч
169 mm (10 1/4
Ч 6 Ч 6 3/4
inches) (w/h/d)
Remote Commander: 56
Ч 26 Ч
210 mm
(2 1/4
Ч 1 1/16 Ч 8 3/8
inches) (w/h/d)
Mass Video camera: Approx. 2 kg (4 lb
7 oz)
Remote Commander: 190 g (3.8 oz)
Installation angle
Less than ± 15 degrees to the
horizontal surface
Supplied accessories
AC power adaptor (1)
AC power cord (1)
Remote Commander (1)
Operating Instructions (1)
Design and specifications are subject to
change without notice.