Vaddio Sony EVI-D70 PTZ Camera - Manual (Page 5)

5
Locations of Controls
Locations of Controls
Main Unit
1
3 4
2
qf
qh
qg
Front
Rear Bottom
5 6 7 8
9 q; qa qs qd
1 Lens
A wide conversion lens can be attached.
2 Sensor for the Remote Commander
3 POWER lamp
4 STANDBY lamp
5 Sensor for the Remote Commander
6 IMAGE FLIP switch
Flips the image upside down and executes Pan/Tilt
movement according to the camera installation.
Normally set this to OFF when you use the camera.
When the camera is attached to the ceiling, set this to
ON.
To change the mode, move the switch while the power
(Continued)
is off (including standby mode). Then turn on the
power using DC power, VISCA command, or the
Remote Commander.
After the mode has been changed, the pre-set setting
saved by the Position Preset is returned to the initial
setting.
It takes about 7 seconds for the image to be displayed
after Pan/Tilt initialization motion has stopped.
Do not turn off DC power until the image has been
displayed.
When the power is on, you cannot flip the image using
this switch.