Vaddio Sony EVI-D70 PTZ Camera - Manual (Page 6)

6
Locations of Controls
Remote Commander
POWER
CAMERA SELECT
1 2 3
AUTO
POSITION
HOME
RM-EV100
RESET PRESET
STD REV
BACK LIGHT
MANUAL
FAR
FOCUS
NEAR
W
T
W
T
1 2 3
4 5 6
PAN-TILT
SLOW FAST ZOOM
L/R
DIRECTION SET
PAN-TILT
RESET
DATA SCREEN
6
7
8
9
q;
1
2
3
4
5
1 CAMERA SELECT buttons
2 FOCUS buttons
AUTO button
FAR button
NEAR button
MANUAL button
3 DATA SCREEN button
When the DATA SCREEN button is pushed, the
camera status is displayed when you are using the
Zoom or Manual Focus functions.
DATA SCREEN can be set to ON or OFF, and
memorized, only with POSITION 1.
When POSITION 1 is recalled, the memorized DATA
SCREEN status is used.
4 PAN-TILT button
Arrow buttons
HOME button
5 L/R DIRECTION SET button
6 POWER switch
7 BACK LIGHT button
8 POSITION buttons
Numeric buttons (Button 1 also works as the STD
button. Button 2 also works as the REV button.)
PRESET button
RESET button
9 PAN-TILT RESET button
0 ZOOM buttons
SLOW T button
SLOW W button
FAST T button
FAST W button
7 IR SELECT switch
8 VISCA RS-422 connector
A VISCA RS-422 connector plug is attached to the
unit at the factory.
9 VIDEO (output) connector
0 S VIDEO (output) connector
qa VISCA RS-232C IN connector
qs VISCA RS-232C OUT connector
qd DC IN 12V connector
qf Tripod screw hole
qg BOTTOM switch
D30
MODE
1 2 3 4
OFF
IR
OUT
OFF
RS
422
RS
232C
38400
bps
9600
bps
1 D30/D31 mode switch
Set this switch to ON to operate the Color Video
Camera using the VISCA commands for the EVI-D30/
D31. (See page 52.)
2 IR SELECT switch
Set this switch to ON to allow the camera output
signals transmitted from the Remote Commander to
the Color Video Camera via VISCA OUT jack. (See
page 35.)
3 RS-232C/RS-422 SELECT
switch
Set this switch to RS422 to operate the Color Video
Camera using the VISCA commands via the RS-422
interface.
To switch modes, make sure that the power is turned
off (excluding standby mode), move the BOTTOM
switch, and then turn the DC power on.
The unit will not switch modes after the power is
turned on.
4 BAUD RATE SELECT switch
Set this switch to 38400 bps to operate the camera
with the baud rate of 38400 bps.
To switch modes, make sure that the power is turned
off (excluding standby mode), move the BOTTOM
switch, and then turn the DC power on.
The unit will not switch modes after the power is
turned on.
qh Ceiling bracket mounting screw holes