Vaddio Sony EVI-D70 PTZ Camera - Manual (Page 52)

52
D30/31 Mode
D30/D31 Mode
Overview
The D30/D31 mode allows you to control the EVI-
D70/P using VISCA commands for the EVI-D30/D31.
Most of the VISCA commands for the EVI-D70/P
correspond to one for the EVI-D30/D31. However,
some of the VISCA commands for the EVI-D70/P are
different from those for the EVI-D30/D31 in
definitions of parameters.
When you send those commands to an EVI-D70/P
whose D30/D31 mode is set to ON, the camera
translates the parameters for the EVI-D30/D31 to those
for the EVI-D70/P and executes the command. The
following parameters are subject to translation.
• Zoom speed
• Zoom position
• Focus position
• Shutter speed
• Pan-tilt speed
• Pan-tilt position
• Iris
• Gain
Notes
• Even if you set the D30/D31 mode to ON, the EVI-
D70/P may not emulate the EVI-D30/D31 perfectly.
This is caused by differences in hardware between
the two models.
• The functions that are provided with the EVI-D30/
D31 but not with the EVI-D70/P cannot be executed.
Switching the Mode
You can switch the D30/D31 mode ON or OFF by
switching the BOTTOM switch at the bottom of the
EVI-D70/P. To change the D30/D31 mode setting,
move the BOTTOM switch to ON or OFF while the
camera’s power is off or the camera is in standby
mode. Then, turn the power on by connecting the
camera to an AC outlet or by using the VISCA
commands or the Remote Commander.
It takes about 7 seconds for the image to be displayed
after Pan/Tilt initialization motion has stopped.
Do not turn off DC power until the image has been
displayed.
The mode will not change if you change the switch
setting of the BOTTOM switch after the power has
been turned on.
After you change the mode, previously saved position
preset data will be lost. (Zoom, Pan/Tilt positions, etc.
will be reset to their initial settings.)