AASTRA DT690 - Manual (Page 91)

1424-EN/LZT103 088 Uen F5 2012-03-14 91
M ESSAGES
8. Press Back.
The number will be saved in the contact list.
15.1.2 Writing and Sending a Message
To write and send a message, do the following:
1. Press Menu, select , and press Select.
2. Select Write new message, and press Select.
3. Write the message and press Send.
Note: The maximum message length is 160 characters (Keys 0-9, * or
# can be used. Keys 0 and 1 contains special characters.) See
figure 14 on page 60 to see all characters. Some characters
require 2 bytes in the final message, which means that the total
number of characters can be less than 160.
4. Dial a number, or press the middle soft key, to enter the contact list.
5. Press Send to send the message.
The first character entered will be an upper level character followed by
lower level characters unless the
is pressed before entering the
character.
When you press a key, the first available character on that specific key
is displayed. To get any of the other characters on that key, press the
key until that character appears in the display. For example, to enter the
character E, press twice on the key 3. E appears in the display and is
selected after a time out or when another key is pressed.
Note: To delete a character, press Clear.
15.1.2.1 Opening a Sent Message
To open a sent message, do the following:
1. Press Menu, select , and press Select.
2. Select Sent, and press Select.
3. Select a message, and press View.
15.1.3 Forwarding a Message
You can forward both received and sent messages to other destinations.
To forward a message to another phone number, do the following:
1. Press Menu, select , and press Select.