Beijer Electronics EPC TA70 AM EN - Manual (Page 21)

Hardware Replacement
6.4 Replacing the Complete Front
The following is needed:
• A new front, see Available Spare Parts for EPC TA70 AM
• A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the complete front of the EPC TA70 AM:
1. Power off the Panel PC.
2. Follow the steps 1-3 and 5 in the
Replacing the Display/Display Cable instruc-
tions, but in step 3, do not remove the display cable .
3. Attach the new front.
4. Re-assemble the unit.
Beijer Electronics, MAEN042 21