Beijer Electronics EPC TA70 AM EN - Manual (Page 36)

Environmental Aspects
10.3 Recycling
The Panel PCs consist largely of aluminum. It is a great advantage in terms of both
resources and the environment if it can be recycled. Make sure that Panel PCs
taken out of service are sent to facilities for electronic scrap.
The manufacturer’s electronic waste is recycled by Stena Technoworld AB.
Aluminum front/rear casings and other covers can be removed and recycled.
Plastic display frames and CF covers must be recycled as hard plastic. The circuit
board contains many valuable metals and should therefore be recycled.
Remove the lithium battery. Electrolytic capacitors and displays are currently not
classified as hazardous waste, but may be harmful to health and the environment.
The electrolytic capacitors should be handled as per Handbook 2001:7 (NFS)
and displays as per NFS 2001:8.
The fluorescent tube must be handled as hazardous waste.
The packaging is made from wood fiber and should be recycled. The large printed
label on the front, however, must first be removed as it is made of PVC vinyl. The
label and the plastic bag for the brackets are recycled as soft plastic.
The manufacturer is a member of the REPA register. The protective film on the
front is recycled as soft plastic. When the Panel PC is no longer useful it can be
returned to the manufacturer for environmentally responsible recycling. Contact
the company for further information.
10.4 Environmental Impact Report
A Panel PC impacts the environment through its function, i.e., controlling
industrial equipment. The energy and the scrapped parts that can be saved
with efficient management mean that the Panel PC contributes to reduced
environmental impact.
Listed below are examples of how you can reduce environmental impact during
Panel PC use.
• Switch the system off when not in use.
• Use green electricity.
• Use energy-saving options, e.g., turn off the backlight to both save energy and
reduce wear on the fluorescent tube.
• If possible, reduce the backlight brightness to reduce energy consumption
and increase fluorescent tube service life.
Supply the Panel PC with 24 V DC. If the input voltage is lower, the loss effect
increases. Ensure that the Panel PC, battery, and packaging are recycled in an
environmentally responsible manner.
Beijer Electronics, MAEN042 36