Beijer Electronics iX Panel T60 EN - Manual (Page 24)

Hardware Replacement
7.5 Replacing the Complete Front
The following is needed:
• A new front, see Available Spare Parts for iX Panel T60
• A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the complete front of the iX Panel T60:
1. Power off the operator panel.
2. Follow the steps 1-6 in the
Replacing the Display/Display Cable instructions .
3. Attach the new front.
4. Re-assemble the unit.
Beijer Electronics, MAEN005 24