Adaptec SANBLOC S50 - Manual (Page 16)

SANBloc S50 Quick Install Guide
FCC Notification
Authorized Service
Only an authorized service representative can service the Server. Failure
to comply with this requirement will void the warranty.
WARNING to Service Personnel
The SANbloc S50 has been tested and found to comply with the limits for
a Class “A” digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to correct the
interference at their own expense.
Changes or modifications not expressly approved by Adaptec could void
the user’s authority to operate the equipment.
Safety Precautions
Note The maximum current draw is printed on the label on the back of
the storage subsystem.
Caution Before touching any enclosure components, ground yourself and
take antistatic precautions. Adaptec recommends that you use an
antistatic wrist strap and a grounding wire as minimum precautions.
Environmental Conditions — Make sure the conditions of the environment
in which the server resides fall within the specifications for your model.
Installing the Server — During installation, make sure the server is always
placed on a surface capable of supporting its weight.