Installing your adaptec enclosure into a rack – Adaptec SANBLOC S50 User Manual
Page 5
3
SANBloc S50 Quick Install Guide
Installing Your Adaptec Enclosure into a Rack
1
Ensure that you have these rackmount kit components:
• Front rails (1 left, 1 right)
• Rear rails, two different lengths (2 left, 2 right)
• 20 nuts (10 each of two different types)
• 4 small screws and 10 large screws
2
Secure the front rails to the front supports of the rack, using the screws
or nuts included in the kit. (Use the nuts if your rack does not have
threaded holes.)
)
3
Select the right length of rails for your rack, then secure them to the
rear supports of the rack, as shown above. Then secure the front rails to
the rear rails.
Ensure that all the rail connections are tightened and secure.
Secure rear rail, using rail
length suitable for your rack
Rear support
Front
support
Secure front rail