Getting started, Newport station – j5 create JUD200 USB 2.0 Newport Station User Manual
Page 8
NEWPORT STATION
USER MANUAL
7
GETTING STARTED
Notes for Before Installation
Install the driver completely before inserting the USB cable into your computer
Run the setup program as an administrator to avoid errors in installation
Connect the VGA of Display device to the VGA port of Newport Station first
before connecting the USB cable to the computer
Un-install the previous driver first before installing the latest driver
Enjoy the Newport Station
1. Start Device Driver Installation (please refer to your PC system OS installation in next
section)
*Note: install driver completely before following steps.
2. Plug the Power Adapter to Port 1
3. Connect USB 2.0 Cable Micro-B connector to Port2, Type-A connector to host laptop
4. Connect VGA Cable of Display device to Port 4
5. Connect Ethernet Cable to Port 7
6. Connect Audio Cable(audio out, audio in)to Port 8 & 9
7. Lay your laptop on the top of the j5 Newport Station
8. Push the “j5” power button
9. USB 2.0 HUB port 3,5,6 are now ready to use