Meteor ProMover 250 - Manual (Page 12)

12
- The interior of the fixture should be cleaned at least annually using a vacuum
cleaner or an air-jet.
- The dichroic color filters, the gobo-wheel and the internal lenses should be cleaned
monthly.
- To ensure a proper function of the gobo-wheel, we recommend lubrication in six-
month intervals.
- Carefully placed quantity of oil must not be excessive in order to avoid that oil runs
out when the gobo-wheel rotates.
- There are no serviceable parts inside the device.
- Maintenance and service operations are only to be carried out by authorized
dealers.
- Please refer to the instructions under "Installing/Replacing the lamp".
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and
rating.
Before replacing the fuse, always unplug mains lead / power cable
Procedure:
Step 1:
Open the Fuse-holder on the rear panel with a slotted screwdriver (below power)
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by
a special power supply cable available at your dealer.
Should you have further questions, please contact your dealer.
Please note: All information is subject to change without prior notice.
Alabama Office
: www.meteor-usa.com
8000 MADISON PIKE /P.O. BOX 578, MADISON ALA. 35758. (256) 461-8000. FAX: (256) 461-7708
Michigan Office:
3471 BEECHER RD, FLINT, MICHIGAN 48532. Telephone:(810) 230-6600. Fax: (810)230-0066
WWW.meteor-kls.com EMAIL: [email protected] www.kls-usa.com EMAIL: [email protected]